[ Log In ]
thumbnail: 3 position female connector with 2.54mm pitch

3 position female connector with 2.54mm pitch

$0.55
Qty:
2x36 pin header IDC

2.54 mm (0.1") Pitch Male Connector 36 pin Header

$0.75
Qty:
molex connector with crimp pins thumbnail

4 Pin Female Molex Connector with Crimp Pins

$3.50
Qty:
Newbie Hack Shirt Back
9V Battery Hold with Wire Leads

9V Battery Holder with Wire Leads

$0.49
Qty:
USB 2.0 Cable 10 Foot Type A Male to Type B Male

USB 2.0 Cable Type A Male to Type B Male - 10 FT

$4.80
Qty:
3 Foot USB Cable Type A to USB Cable Type A

USB Cable Type A Male to USB Type A Male - 3 FT

$2.65
Qty:
Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

$8.99
Qty:
Type K Thermocouple Temperature Sensor

Type K Thermocouple - Temperature Sensor

$4.95
Qty:
Tumbnail: 62 oz-in NEMA 17 Stepping motors (also called stepper motor)

NEMA 17 Stepping Motor (62 oz-in 5mm single shaft)

$19.95
Qty:

4 Pin Female Molex Connector with Crimp Pins

Molex connector and crimp pins 3.96mm pitch spacing
Molex connector and crimp pins 3.96mm pitch spacing

Introduction:

We use this connector with our 2.5 amp stepping motor driver that is used to drive 3D Printers. Our standard 4 conductor cable is perfect for this connector. The crimp pins can be used with wire sizes between 18-24 gauge (AWG). The pitch (spacing between pins) is 3.96mm or .155 inches.

Description:

4 Pin Female Molex Connector with Crimp Pins

$3.50
Qty:

Learn about the 4 Pin Female Molex Connector with Crimp Pins

Part 1: Making a convenient connector from a 2x3 female header to an inline 6 pin male header for SPI communication from USBTiny at the computer end to the microcontrollers MOSI, MISO, SCK, Reset, VCC...
A standard pair of needle nose pliers is used to crimp this crimp pin since this is the tool that most have rather than the more expensive crimping tool. The needle nose pliers is first used to clo...
Soldering a wire from one location on a perf board to another location on a perf board using a wire stripper, soldering iron, perf board and solder. Specifically for the MISO (Master In slave Out).
Soldering a wire from one location on a perf board and to a header pin to another location on a perf board and to a header pin using a wire stripper, soldering iron, perf board and solder. Specificall...
Soldering a wire from one location on a perf board and to a header pin to another location on a perf board and to a header pin using a wire stripper, soldering iron, perf board and solder. Specificall...