[ Log In ]
Newbie Hack Shirt Back

16x2 LCD (Liquid Crystal Display)

16x2 LCD (Liquid Crystal Display)

$12.50
Qty:
Thumbnail: Crystal Oscillator 18.432 MHz for UART

18.432 MHz Crystal Oscillator 18pf 30ppm

$0.94
Qty:
Thumbnail: 22 pF Capacitor

22 pF Multilayer Ceramic Capacitor

$0.43
Qty:
Thumbnail: Quartz crystal oscillator - 16 MHz

16 MHz Crystal Oscillator 20 pF Through Hole

$0.75
Qty:
Front of the 128x64 display module

128x64 OLED Display Yel/Blu

$17.95
Qty:
USB 2.0 Cable 10 Foot Type A Male to Type B Male

USB 2.0 Cable Type A Male to Type B Male - 10 FT

$4.80
Qty:
Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

$8.99
Qty:
3 Foot USB Cable Type A to USB Cable Type A

USB Cable Type A Male to USB Type A Male - 3 FT

$2.65
Qty:

18.432 MHz Quartz Crystal Oscillator

Crystal Oscillator 18.432 MHz for UART
Crystal Oscillator 18.432 MHz for UART

Introduction:

Use this crystal with UART communication on your Microcontroller. Here is a crystal that you can add to your microcontroller that will enable you to get low error rates when establishing communication with UART baud rates. The 18.432 MHz frequency allows the microcontroller to establish standard baud rates, like 9600, 115200, etc.

Description:

18.432 MHz Crystal Oscillator 18pf 30ppm

$0.94
Qty:

Learn about the 18.432 MHz Quartz Crystal Oscillator

The power requirements for the the two microcontrollers (Atmega32 and Atmega324): Atmega32 - 4.5v to 5.5v Atmega324A - 1.8v to 5.5v (a much broader range of voltages) Atmega324P - 2.7v to 5.5v
The power pins of for the Atmega32, Atmega324A, Atmega324P and other pin compatible AVR microcontrollers are located at pin 10 (VCC) and pin 11 (GND).
The UART communicates at a agreed upon speed set by the baud rate. This baud rate must be set in both the transmitting and receiving microcontrollers to work. Includes Code
Introduction to the Atmel Atmega32 AVR microcontroller and the pin assignments (what each pin of the chip does). The pins include PORTs (PORTA, PORTB, PORTC and PORTD) and 8 pins for each port, ADC (...
Part 1: Making a circuit for the Atmel AVR Atmega32 microcontroller to light up an LED (Light Emitting Diode). The circuit consists of an LED, a resistor of the appropriate value to limit current to ...