[ Log In ]
[ Your Cart ]
Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

$8.99
Qty:
White prototyping breadboard with 30 tie strips and two power rails on each side.

White Prototyping Breadboard (2x30 columns of tie strips and 2x2 rows of power strips)

$7.95
Qty:
Clear Semi Transparent Breadboard

Clear Prototyping Breadboard (2x30 columns of tie strips and 2x2 rows of power strips)

$8.50
Qty:
Thumbnail: A bundle of 65 jumper wires of various length and color. Bound together with the male connectors shown in the foreground.

Bundle of 65 Male to Male Flexible Jumper Wires

$8.95
Qty:
A single mini breadboard 17X10. Black color.
Single White 17X10 mini breadboard
Single Blue 17x10 Mini Breadboard
A single 17x10 mini breadboard (Red)
Single Green Mini Breadboard

Jumper Wire Pack 140 Pieces Multi-Size Multi-Color

$6.75
Qty:

Probe Lead Cable 500v - Banana Security Plug

Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V
Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

Introduction:

These leads are great for grasping wires and resistors that are otherwise difficult to test with regular multimeter or oscilloscope leads.

Description:

Cable Gauge: 0.5mm

Current: 5A

Voltage: 500V

Cable Length: 3.28' (100cm)

Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

$8.99
Qty:

Learn about the Probe Lead Cable 500v - Banana Security Plug

How to measure DC Voltages with a Multimeter
The black lead should be plugged into the COM (common) plug. The red lead should be plugged into the voltage plug, not the amps plug. This could blow a fuse inside the multimeter. Set the dial of t...
How to measure AC Voltages with a Multimeter
The black lead should be plugged into the COM (common) plug. The red lead should be plugged into the voltage plug, not the amps plug. This could blow a fuse inside the multimeter. Set the dial of t...
How to measure resistances with a Multimeter
The black lead should be plugged into the COM (common) plug. The red lead should be plugged into the ohms plug, not the amps plug. This could blow a fuse inside the multimeter. Set the dial of the ...
Determine the Resistance that must be Connected to the base Lead of a Transistor
A resistor will most likely be needed at the base lead of a transistor if the transistor will be used as a switch. The formla below is a special formula that is used only if the supply voltage is the... Includes Code
How to Choose a Multimeter
The multimeter should be able to measure voltage, current, resistance and continuity. A couple of good options is to be able to measure capacitance and temperature. The accuracy of the multimeter sho...
About Us - Site Map - Donate
© Copyright 2020, PHD Robotics, LLC. dba NewbieHack.com