[ Log In ]
Thumbnail: 22 pF Capacitor

22 pF Multilayer Ceramic Capacitor

$0.43
Qty:
40 pin IC Socket with mechanical pencil in background for scale.

40 pin IC Socket

$0.89
Qty:
Newbie Hack Shirt Back
.1uf (100nf) ceramic capacitor

Single .1uF (100nF) 50V 10% Through Hole Ceramic Capacitor

$0.24
Qty:
10uF Through Hole Electrolytic Capacitor

Single 10uF Through Hole Electrolytic Capacitor

$0.44
Qty:
thumbnail: 100uF 50v through hole aluminum electrolytic capacitor

100uF/50v Through Hole Electrolytic Capacitor

$0.36
Qty:
Thumbnail: Crystal Oscillator 18.432 MHz for UART

18.432 MHz Crystal Oscillator 18pf 30ppm

$0.94
Qty:
Thumbnail: MAX603 Voltage Regulator
Thumbnail: Quartz crystal oscillator - 16 MHz

16 MHz Crystal Oscillator 20 pF Through Hole

$0.75
Qty:
USB 2.0 Cable 10 Foot Type A Male to Type B Male

USB 2.0 Cable Type A Male to Type B Male - 10 FT

$4.80
Qty:

10uF Through Hole Electrolytic Capacitor

10uF Through Hole Electrolytic Capacitor
10uF Through Hole Electrolytic Capacitor

Introduction:

Dipped radial multilayer ceramic capacitor with a capacitance of 10uF (micro-farad).

Description:

These 10uF capacitors are used for filtering low frequency ripple in the power lines.

Single 10uF Through Hole Electrolytic Capacitor

$0.44
Qty:

Learn about the 10uF Through Hole Electrolytic Capacitor

The 7805 Voltage regulator outputs 5 volts and requires at least 8 volts at the input (high dropout voltage). The middle pin is connected to ground. Capacitors are needed to reduce the peak to pea...
The 7805 voltage regulator is connected to a breadboard to provide 5 volts to the circuit. Two capacitors are connected to the voltage regulator, 10uf (microfarad) on the input and .1uf on the output...
The MAX603 is a Voltage Regulator that will provide 5v output and can accept a voltage very close to this output voltage featuring its low dropout. The input voltage is connected to pin 1 and the o...
Capacitors can be used to smooth a rough or noisy signal. In this case, an accelerometer is being read by the ADC. The ADC is seeing a very noisy signal from the accelerometer. A 10 uf (micro far...
The pressure sensor is connected to the MAX604's output voltage to pin 2 of the sensor for VCC and pin 3 for GND.