[ Log In ]
9V Battery Hold with Wire Leads

9V Battery Holder with Wire Leads

$0.49
Qty:
4 AA Battery Holder with Wire Leads

4 x AA Battery Holder with Wire Leads

$1.29
Qty:
Newbie Hack Shirt Back
USB 2.0 Cable 10 Foot Type A Male to Type B Male

USB 2.0 Cable Type A Male to Type B Male - 10 FT

$4.80
Qty:
3 Foot USB Cable Type A to USB Cable Type A

USB Cable Type A Male to USB Type A Male - 3 FT

$2.65
Qty:
Type K Thermocouple Temperature Sensor

Type K Thermocouple - Temperature Sensor

$4.95
Qty:
Tumbnail: 62 oz-in NEMA 17 Stepping motors (also called stepper motor)

NEMA 17 Stepping Motor (62 oz-in 5mm single shaft)

$19.95 Out of Stock
Qty:
Image of the Atmega324p

Atmega324P

$8.50
Qty:

10K timmer potentiometer

10K Trimmer Potentiometer (Through Hole)

$0.85
Qty:

9V Battery Holder with Wire Leads

9V Battery Hold with Wire Leads 9V Battery Holder with Wire Leads, shown with mechanical pencil for scale.
9V Battery Hold with Wire Leads 9V Battery Holder with Wire Leads, shown with mechanical pencil for scale.

Introduction:

This is a snap connector for 9V battery. The wire leads are 6 inches (150mm) long.

Description:

-

9V Battery Holder with Wire Leads

$0.49
Qty:

Learn about the 9V Battery Holder with Wire Leads

The pressure sensor is connected to the MAX604's output voltage to pin 2 of the sensor for VCC and pin 3 for GND.
The center lead (Vout) of the potentiometer is connected to the ADC pin 0. The potentiometer's outer leads are connected to ground (GND) and 5V (VCC). These connections create the voltage divider. O...
Wall Adapters have an input voltage generally between 110v or 220v. This voltage may read 115v, 120v, 230v or 240v. the output voltage will vary widely. This usually depends on the application of t...
A voltage regulator takes a higher voltage and provides a set voltage that the regulator is designed to output. There are a few types of regulators: switching regulators, high dropout regulators and ...
Part 1: Making a convenient connector from a 2x3 female header to an inline 6 pin male header for SPI communication from USBTiny at the computer end to the microcontrollers MOSI, MISO, SCK, Reset, VCC...