• 1/4" barbed to 1/4" NPT tube fitting
  • 1/4" barbed to 1/4" NPT (National Pipe Thread) tube and hose fitting showing from the barbed side
  • Showing the length of the 1/4" barbed to 1/4" NPT tube and hose fitting. Length is 1.6255 inches
1 3

BuildYourCNC

Rohrverschraubung 1/4" Tülle auf 1/4" NPT Außengewinde

Rohrverschraubung 1/4" Tülle auf 1/4" NPT Außengewinde

$6.25 USD
$6.25 USD
Sale Ausverkauft
Versand wird beim Checkout berechnet
Titel
Ein Schlauchanschluss mit 1/4" Widerhaken auf Außengewinde passt zu einem Schlauchanschluss mit 1/4" Innengewinde, um einen flexiblen Schlauch an Wasser- oder Luftwerkzeuge anzuschließen. Dieser Schlauchanschluss mit 1/4 Zoll Widerhaken auf 1/4 Zoll NPT Außengewinde ist ideal zum Anschließen von flexiblen Schläuchen an Stecker, Luftwerkzeuge, Wasserpumpen oder andere luftbetriebene Maschinen. Schlauchanschlüsse werden im Allgemeinen zum Verbinden, Abzweigen und Ändern der Richtung von Schläuchen in pneumatischen und hydraulischen Systemen verwendet.
  • 1/4" Widerhakenende zum Anschluss an einen Schlauch und ein 1/4" National Pipe Taper (NPT) Außengewindeende zum Anschluss an einen Stecker oder ein Werkzeug
  • Luftleitungsanschluss zum Verbinden flexibler Schläuche mit Luftwerkzeugen oder Wasserpumpen
Vollständige Details anzeigen

Questions & Answers

Have a Question?

Ask a Question

  • I'm using the big 651oz in stepper motor for X and Y and the smaller 325 for the z and X and Y keep tripping when I try to tune the motors on Mach3 but Z seems to work. I have to turn power on and off to reset....is this a wiring issue?

    This is most likely a wiring issue. I would disconnect all of the power to the drivers and reconnect one at a time to isolate the problem. Additional Information: that was not helpful. I already did that way before submitting this question. there are not that many wires here and I have already rewired this a few times. I actually think its a software or interface board issue because it does work sometimes but then trips (possibly a amperage / voltage issue) I am using the interface board that has a parallel port and usb for 5V. are there different settings that I need to setup?

  • I have a vacuum regulator pump controller that I purchased from you previously. The LCD display is now missing the bottom line of text. Have you run into this issue before? Can I just swap out the LCD displays or is a fix going to be more involved?

    It appears that the LCD that you have on the vacuum pressure controller is damaged. You will need to remove the LCD (desolder the LCD) that is on the controller and resolder a new one. Here is a link to the LCD used for that vacuum pressure controller: https://newbiehack.com/categories/newbiehack-LCD_Displays_and_LEDs-LCD-16x2 Newbiehack is a sister website to buildyourcnc.