Onsrud Oberflächenfräser

DO NEED TO GET THE BIG PLANING BIT OR SURFACING AND GO OVER SPOIL BOARD MAKE SURE THAT IT IS PERFECTLY LEVEL IN RELATION ROUTER?

Yes, that is highly recommended for all the reasons you can imagine. Say you were doing engraving, not surfacing the spoilboard will either exhibit some areas that have no engraving at all, or areas that have engraving that is too deep. If you are cutting completely through the material, then one end may be cut all the way through but the other end will not have a complete cut, or produce onion skinning on the bottom of the workpiece.

What is the max thickness of material that the 80W laser can cut in plywood?

An 80 watt laser can cut plywood up to 1/2 inch thick. Make sure to use a high pressure source of air to knock out all of the charring during the cutting process so the laser can work efficiently. Additional Information: I have a Chinese 80W laser. Just finished a cut test with 1/2" plywood. It cut through at 95% power 7-4mm/s with significant charring after two passes with no refocusing done between passes. Additional Information: That's great information. What is your PSI of the air assist on your laser? What focal lens distance do you have? And where did you place the focus of the lens (at the surface, or within the material)?

what is the horse power rating for the 2.2 kw spindle motor

2.2 kW spindles have 2.95 HP.

DO YOU TYPICALLY PUT SPOILER BOARD ON TOP, IF SO HOW ATTACH IT?

Yes, this is a must. You can attach the spoil board on the machine with screws, or you can setup a clamping system. We just screw it down.