Single Phase 220 supply to VFD. R=Neutral, S=110 Leg, T=110 Leg?? Not sure after reading up on this..

When connecting the VFD to 220v, use the wiring diagram on this page to properly connect the wires from the 220v socket to the terminals of the VFD: https://buildyourcnc.com/item/spindle-inverter-2!2kw-spindle-novfd Other than that, you will need a certified electrician to make sure that the wall socket is correctly wired to the fuse panel.

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.