[ Log In ]
40 pin IC Socket with mechanical pencil in background for scale.

40 pin IC Socket

$0.89
Qty:
Newbie Hack Shirt Back
3 pin slide switch

SPDT Slide Switch 3 pin 30V

$1.49
Qty:
Tactile momentary push button switch 6 mm x 6 mm (through hole)
LED button tactile switch

LED Button Tactile Switch

$1.89
Qty:
USB 2.0 Cable 10 Foot Type A Male to Type B Male

USB 2.0 Cable Type A Male to Type B Male - 10 FT

$4.80
Qty:
Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

$8.99
Qty:
3 Foot USB Cable Type A to USB Cable Type A

USB Cable Type A Male to USB Type A Male - 3 FT

$2.65
Qty:
Type K Thermocouple Temperature Sensor

Type K Thermocouple - Temperature Sensor

$4.95
Qty:
Tumbnail: 62 oz-in NEMA 17 Stepping motors (also called stepper motor)

NEMA 17 Stepping Motor (62 oz-in 5mm single shaft)

$19.95
Qty:

Push Button Momentary Switch (through hole)

Tactile momentary push button switch 6 mm x 6 mm (through hole)
Tactile momentary push button switch 6 mm x 6 mm (through hole)

Introduction:

Push button switches are used to provide input to microcontrollers and electronics. Press the button to complete the circuit.

Description:

This is the type of tactile push button switch that has a momentary action which means, the switch is activated only when it is depressed. When the push button is released, the switch is disengaged.

Specifications:Size: 6 mm x 6 mmMounting type: through holeOperating force: 100 gType: SPST (Single Pole Single Throw)

Please Make a Selection:

Qty:

Learn about the Push Button Momentary Switch (through hole)

The push button switch is connected to the first pin of the microcontroller (PORTB Pin 0) and the other end of the button is connected to ground since the pin will be in a high state.
Programming for push button switch functionality on the Atmel AVR microcontroller on PORTB Pin 1 using the condition that uses the bit_is_clear(PIN?, ?) function. In this case, the push button has a ...
Schematic on paper of one button with hardware debouncing and two LEDs (Light Emitting Diodes) connected to an AVR microcontroller. The push button switch is connected to pin 1 on PORT B and the LEDs...
Breadboard circuit of one button with hardware debouncing and two LEDs (Light Emitting Diodes) connected to an AVR microcontroller. The push button switch is connected to pin 1 on PORT B and the LEDs...
The hobby servo is connected to the microcontroller using three wires, the VCC, GND and signal wire. The signal wire is connected to the OCR1A pin of the AVR microcontroller which will output the PWM...