[ Log In ]
STM32F0 microcontroller and interface board top view

STM32 M0 MCU and Interface to Breadboard

$14.95
Qty:
3 pin slide switch

SPDT Slide Switch 3 pin 30V

$1.49
Qty:
Newbie Hack Shirt Back
The STM32 ultra basic kit showing all of the components

STM32 Ultra Basic Kit Special Introductory Price!

$34.95
Qty:
ST Link v2 for STM32 and STM8 microcontrollers top view of all components

ST-Link v2 STM32 and STM8 Programmer

$9.95
Qty:
Image of the Atmega324p

Atmega324P

$8.50
Qty:
Serial to USB converter with Micro USB cable

USB to Serial Converter

$10.95
Qty:
Thumbnail: Crystal Oscillator 18.432 MHz for UART

18.432 MHz Crystal Oscillator 18pf 30ppm

$0.94
Qty:
Thumbnail: 22 pF Capacitor

22 pF Multilayer Ceramic Capacitor

$0.43
Qty:
Thumbnail: Quartz crystal oscillator - 16 MHz

16 MHz Crystal Oscillator 20 pF Through Hole

$0.75
Qty:

STM32 Microcontroller and Interface Board

STM32F0 microcontroller and interface board top view STM32F0 Microcontroller and interface card bottom view Close-up of the stm32 microcontroller soldered to the breadboard interface board
STM32F0 microcontroller and interface board top view STM32F0 Microcontroller and interface card bottom view Close-up of the stm32 microcontroller soldered to the breadboard interface board

Introduction:

This is an ARM Cortex-M0 microcontroller/processor and an interface card that plugs into a breadboard for direct prototyping. Get started with ARM embedded programming.

Description:

The configuration of the main board with headers will fit on three breadboards enabling a vast array of tie strips for use in prototyping. The board is completely soldered, so you can simply plug this board into the breadboard and start prototyping.

This particular ARM processor has the following specifications:32-bit of data bus width, maximum clock frequency of 48 MHz, 64 kB of Program Memory, 8 kB of RAM (SRAM), Analog to Digital precision is 12-bits, will accept voltages of 2.4v to 3.3v (3.3 volts is typical), package of the processor itself is 64 LQFP (Low profile Quad Flat Pack), 16 analog to digital channels, contains 55 I/O pins and 7 timers.

STM32 M0 MCU and Interface to Breadboard

$14.95
Qty:

Learn about the STM32 Microcontroller and Interface Board

An interface (breakout) was created to make the connection from the LCD to the microcontroller easier. The DIY interface contains a trimmer potentiometer to adjust the contrast of the LCD. The inter...
Introduction to programmers line the USBTiny and the Pocket AVR and that this device is plugged into the computer and to the microcontroller (chip) to transfer the program from the computer to the mic...
Breadboard circuit of one button with hardware debouncing and two LEDs (Light Emitting Diodes) connected to an AVR microcontroller. The push button switch is connected to pin 1 on PORT B and the LEDs...
A wall adapter can be used to power the microcontroller circuit. It is recommended to use a voltage regulator with this wall adapter to insure that the proper voltage is powering the circuit. Too mu...
Since this Freescale accelerometer requires a different voltage than the AVR microcontroller, another voltage regulator is used (Maxim MAX604). The MAX604 will be positioned on the other extreme side...